Description
- Warm Tips: To figure out your values for the Sensitivity , Please set the delay time to its minimum value first , this will save your time.
- Motion Activated: Sensor function triggered by motion, you can use this small motion sensor switch to control lighting like Led strip lighting.
- Delay Time Adjustable: The delay time controls how long the light stays on once it gets triggered, during the delay time if motion detected, the delay time will reset and start a new delay time.
- Sensitivity Adjustable: The sensitivity controls how close you need to be to the sensor in order to activate it.
- Wide Application: You can use this sensor switch in different occasions like entryway lighting, cabinet lighting, gun safe lighting, pantry lighting, under the bed rails lighting.
Description\n\n PIR(Passive infrared) Motion sensor is pyroelectric device can detect human movement by detecting Infrared ray emitted by human body. Operating voltage is 5~25VDC, output voltage is equal to input voltage. High sensitivity, easy to install, widely used on the Motion-activated lighting, LED strips Security System, automatic sensory device and more.\n\n\nSpecifications\n\n Operating voltageDC12V\n Load current3A\n Delay timeDefault setting15sec (2~360 Seconds is adjustable)\n Detecting range : About 110 degrees cone angle\n Detecting distance: 5M-7M\n Trigger way : continuous triggering\n Blockade time: 0 seconds\n size 48*25*14 mm\n\n\nApplication\n\n Clock-wise reduce the delay time\n Anticlockwise increase the delay time\n\n\nFunctions and Features\n\n Automatic Induction: When people enter into the range of induction, it will output a voltage equal to input voltage, after the delay time, it will output 0V; during the delay time if motion detected, the delay time will reset, and start a new delay time.\n\n\nNote: \n\n 1.Don\'t exposed to direct sun light or lighting, big wind, near a heater or air condition.\n 2.Don\'t fix it at a place where there are obstructing material (e.g. Glass, dense clothes) which IR cannot get though.\n 3.Don\'t fix it in strong shock or vibration environment.\n 4.The PIR Sensor requires a \'warm-up\' time in order to function properly, about 10s to1min,depend on the delay time; during this time, the signal triggered by the module is not stable, after one minute, it will be ready.